![jim becker audio tuner jim becker audio tuner](https://www.original-autoradio.de/ebay/mb/mf2910gs13cd1.jpg)
I mapped the FAV button on the remote to do the 30-second skip by following this procedure:ġ) Press the "Cable" button at the top of the remote to put it into Cable Box control mode.Ģ) Press and hold the "Setup" button until the "Cable" button blinks twice.ģ) Type in the code 994. It is possible to remap any of the buttons on the silver remote that Comcast provides to the 30-second skip function.
#Jim becker audio tuner full
Ken, I hope I didn't violate and rules by posting a full address above. Lots of other good stuff on the forums mentioned. I’m guessing that’s the way they programmed it, to shut it off if it had been before the recording started.
![jim becker audio tuner jim becker audio tuner](https://i.ytimg.com/vi/mAFPzBEe9b4/hqdefault.jpg)
Also if you turn the box on while it is recording, unmute it, after the recording is done it will shut the box off. cgi-bin2/ueic.cgi?cbl_0476 Cut/paste then replace the XXX with On the hifi-remote code page they have the codes as 3 digit numbers so I just added 2 zero’s to the front of the ones I used.
#Jim becker audio tuner how to
There are also other codes too on this forum and page (had to put full http: address didn’t know how to get to this page otherwise. To remap your remote for a cable box Mute button use the procedure below except use code 00141. Never had a TiVO so I don’t know if their commercial skip works the same way or not. This worked great! There was also a discussion I came across for remapping a button for a 30 second skip (see below ). Came across a remapping procedure (see below) on a forum (avsforum in a discussion thread Comcast Motorola 6208 HD DVR Users Thread ) that had lot of good info on Motorola DVR’s. Now being that the mute button on the remote only operates the mute button for my TV then the only way you can get the sound back without stopping the recording and turning the DVR off then back on is by reprogramming your remote for the mute control on your cable box. Later I noticed at the top of the screen I could just barely see the bottom of the word MUTE. Found out that if the box was off and it started a recording the box would mute the audio output. Was trying to find out why when I turn the box on sometimes that there is no sound. I was searching for some info on the Dual Tuner DVR cable box (Motorola 6412) I got from Comcast.